usb layout注意事項
‧D+/D-走线.1.D+/D-必须保持等长平行走线,线间的距離必须设计在90Ω的差动阻抗。(如图一).D+/D-走线须在同一层面,尽可能不要走在其它层面。(如图一).,以最短走線長度走D+/D-、Clock和週期信號;D+/D-應和PCB上的Connector盡量保持遠離(例.如I/Oconnector,控制訊號接頭...
(1)USB接口的定义及布局布线要求
- usb layout阻抗匹配
- St usb esd protection
- esd pad layout
- ic layout esd
- usb esd保護
- rj45 esd layout guidelines
- XTAL layout Guide
- esd layout rule
- esd protection diode原理
- usb tvs protection
- usb layout rule
- esd protection diode
- esd protection diode layout
- esd pcb layout
- esd protection circuit
- esd pcb layout design
- esd diode layout
- usb 3.0 layout guide
- usb protection circuit
- usb 3.0 layout design
- usb協會
- usb esd protection circuit
- An_146 usb hardware design guidelines for ftdi ics
- esd layout guide
- usb layout阻抗匹配
2019年11月14日—根据笔者多年USB相关产品设计与调试经验,总结以下注意要点:.1.在元件布局时,尽量使差分线路最短,以缩短差分线走线距离(√为合理 ...
** 本站引用參考文章部分資訊,基於少量部分引用原則,為了避免造成過多外部連結,保留參考來源資訊而不直接連結,也請見諒 **